1" Pixel Blade

Neopixel blades contain a circuit board with individually controllable RGB LEDs on both sides. This allows you to create a wide variety of effects that are not possible with the illumination of a blade by a high-power LED. The characteristic scrolling effect during powering the blade up and down, localized flash on clashes or lockups as well as different blade profiles can be displayed this way. Furthermore, the brightness is significantly higher compared to high-power LED-lit sabers.

In order to use a Neopixel blade, the saber must have a matching connector on the hilt side, so it cannot simply be inserted into a saber with a high-power LED.

Our Neopixel blades are compatible with all sabers that have the matching Hilt Side PCB. This is the same or similar across most manufacturers in its function and basic design. Definitely our blades work with the sabers of the following manufacturers:

• Vader's Vault
• Sabertrio
• Genesis Custom sabers
• JQ Sabers
• Electrum Sabercraft
• Saberforge

and others. If you are unsure whether our blade fits your saber, just send us an email to shop@saberproject.de.

Attention: Due to the construction of the blade and the included circuit board, the blade is only conditionally suitable for combat. We therefore expressly exclude combat damage from the warranty and guarantee.

Technical data: 

• Transwhite polycarbonate blade (1" outer , 7/8" inner diameter) with parabolic blade tip.
• KR Sabers Pixel Stick (150 LEDs/m)
• TCSS Blade Side Connector
• Length: 32.5" (~83 cm)

A dust cap is included.